If your printer show P07 error it means that your
ink absorber inside the printer is almost full. In order to solve this you need
to clear or reset the counter protection of your printer. To do this, follow
this steps.
First make sure that
the power cable and usb cable are connected, before you perform the reset
procedure. And download the resetter at the bottom of this post.
You have to enter in
service mode in order to used the resetter. To do that follow this procedure,
1. Turn off the
printer without pulling the power cords.
2. Hold down
STOP/RESET button and press Power button.
3. Keep holding down
Power button and let STOP/RESET button go.
4. Then Press
STOP/RESET button twice then let BOTH buttons go.
5. You will notice
that the Alternate Blinking error is gone, this means that the printer is in
Service Mode state.
SECOND STEPS: Using the Resetter
1. After you download
the resetter, extract it and double click "servicetool.exe"
2. Load some
papers in your printer and press the "Main" Button once, wait
until the printing is done.
3. Then press "EEPROM
Clear" button to clear EEPROM.
4. Then press EEPROM
button and the printer will print some text.
5. Then power off the
printer(sometimes you have to press twice the power button to turn off) and
turn on again. and its done!
Read More...
Read More...
Any Kind of Canon Printer
Problems Call Us
+1-855-517-2433 (Toll Free)
+1-855-517-2433 (Toll Free)
No comments:
Post a Comment
Note: only a member of this blog may post a comment.